Build Your Own Silver Strapping, Brackets & Hardware Package
Follow the steps below to build your own semi-custom package to attached one sign to a post.
STEP 1: Strapping
-
Snap Lock Assembly
(Skip Step 2, go to Step 4) -
Stainless Steel Strapping
(Go to Step 2)
STEP 2: Buckle or Seal Bracket
Buckle or Seal Bracket not needed, if Snap Lock Assembly was picked in Step 1.
- Buckle for .030" or thicker strapping
- Wing Seal for .025" or thinner strapping
STEP 3: Sign Bracket
(2) Sign Brackets needed to mount 1 sign to a post.
- Cantilever Sign Bracket
-
Minus 4 Sign Bracket
for Posts 4" in Diameter or Less -
Plus 4 Sign Bracket
for Posts Over 4" in Diameter
STEP 4: Hardware
-
5/16" x 18 x 3/4" Stainless Steel Bolt
Just the right length to fit the threaded PLUS 4 or Minus 4 Bracket. -
5/16" Stainless Steel Nut
Only required for cantilever sign bracket.
